On an optical fibre job, a reliable measurement makes the difference between a link delivered first time and hours of fault-finding. But you still need to use the right instrument at the right time. Power meter, laser source, VFL, OTDR or inspection microscope: each answers a different question. Here is how to tell them apart.
The power meter and the laser source: measuring end-to-end attenuation
Used with a stabilised light source, the optical power meter (or power meter) measures the power received at the end of a link. The difference between the transmitted power and the received power gives the total attenuation of the link, to be compared with the theoretical link budget.
It is the reference measurement for the acceptance of a network: simple, fast and easy to document. On live FTTH networks, selective PON power meters also make it possible to measure each downstream wavelength separately without interrupting the service.
The VFL: visually locating breaks and bends
The VFL (Visual Fault Locator) injects visible red light into the fibre. Where the fibre is broken, poorly connected or bent too tightly, the light escapes and becomes visible through the coating or at the connector.
Indispensable in optical patch panels and enclosures, it is also used to check continuity and to identify one fibre among others. Its range remains limited to a few kilometres: it is a close-range tool, not a long-distance diagnostic tool.
The OTDR: the complete map of the link
The OTDR sends out light pulses and analyses the backscattered and reflected light. It produces a trace that locates every event along the fibre: splices, connectors, couplers, bends and breaks, with their distance and loss.
- Typical measurements at 1310 and 1550 nm in single-mode, and at 1625 or 1650 nm for the maintenance of live networks.
- Use a launch cable to properly qualify the first and last connectors, which would otherwise be hidden by the dead zone.
- A bidirectional measurement gives a more accurate loss value at splices.
It is the diagnostic tool par excellence, and the proof of quality expected by many operators on delivery.
The microscope: the habit never to forget
A dirty or scratched connector is one of the leading causes of losses and reflections on a network. Before any connection, and even before measuring, inspect and clean the connectors with a microscope or an inspection probe. A speck of dust invisible to the naked eye is enough to distort a measurement, or even permanently damage a connector end face.
Inspect, clean, inspect again, then connect: a routine of a few seconds that avoids the majority of nasty surprises.
In summary: which instrument for which question?
- Does the link meet its loss budget? Power meter and laser source.
- Where is the break or the bend? VFL over short distances, OTDR beyond.
- What is the quality of each splice and connector? OTDR.
- Is the connector clean? Inspection microscope.
Not sure which equipment to choose, or need a device suited to your jobs? Discover our Tests and measurements range or contact our teams for personalised advice.
A project, a question?
Our teams advise you on choosing equipment, maintaining your equipment or the training courses suited to your technicians.
Categories

